Quick Answer: How Reliable Is The 5.7 Hemi?

What year Ram is the most reliable?

2018Out of all used model years, the 2018 RAM 1500 appears to have the least amount of overall complaints and receives CarComplaints.com’s rank as best used RAM 1500 model year.

Garnering just 12 total complaints, the 2018 model year seems to be more reliable than other pre-owned RAM 1500s..

Why do Hemi engines tick?

Low quality fuel can cause the hemi tick. Fuels that contain high amounts of ethanol or that are low octane may not properly lubricate the fuel injectors and can lead to a slight tapping or ticking noise. Low-octane gas has also been known to cause an ignition knock in high-performance engines.

How can I make my 5.7 Hemi more powerful?

Get more power out of your 5.7 Hemi and give your engine an extra punch with compressed air to blast through the cylinders. Turbochargers and superchargers give your Dodge Ram 1500 bolt on horsepower and torque while doing very little to your fuel efficiency.

What is the best performance chip for 5.7 Hemi?

Comparison Table of Top 10 Best Tuner For 5.7 Hemi RamPriceModelCheck PricePedal Commander ThrottleCheck PriceBully Dog GT Platinum 40410Check PriceSuperchips 3845 FlashpaqCheck PriceTrinity T2 EX Performance5 more rows

How many miles can a 5.7 Hemi engine last?

250-300 000 miles5.7 Hemi engines are good for 250-300 000 miles and more if properly cared for and regular maintenance is carried out. Early models suffered from valve seat issues which was rectified after 2008. It’s not uncommon to find high mileage 5.7 Hemi trucks running around today.

Is the 5.7 Hemi fast?

5.7L HEMI® V8 The 5.7L V8 HEMI® engine is available only on the R/T trim This engine offers 370 horsepower with 395 lb-ft of torque. With this powerful HEMI® upgrade, you’ll get a 0-60 mph of 5.2 seconds and a ¼ mile time of 13.7 seconds.

Is 5.7 Hemi a good engine?

In general, the third-generation Hemi V8s don’t have any significant design flaws, and the 5.7L version is a solid reliable engine. Many owners are faced with a strange ticking sound in the 5.7L Hemi engine coming from the valvetrain, which, however, does not affect anything.

Can lifter tick cause damage?

If you hear a ticking or tapping noise in your vehicle’s engine, it is a lifter tick. Lifter tick can be continuous or occasional, and it can be tapping, ticking, or clicking. … It is recommended that you do not ignore any weird sounds in your vehicle as they might cause severe damages in the long run.

Why are used Dodge Rams so cheap?

Ram’s have been historically cheaper because they have spent their entire lives trying to break into the truck market. F150 and Silverado have been #1 and #2 in the truck game for decades. Ram has mostly settled for #3 (with a few exceptions.)

Why are Ram trucks so unreliable?

Like the other models on CR’s list of unreliable 2020 full-sized pickup trucks, the Ram’s low-reliability rating stems from a history of NHTSA vehicle safety recalls. The 2020 Ram 1500 currently has four recalls on it. These relate to potential issues with the truck’s airbags, back up camera, and windshield.

How much horsepower can you get from a 5.7 Hemi?

5.7L Hemi Applications and Estimated Horsepower The engine displaces 5.7L or 348 CID, and at its introduction produced one horsepower per cubic inch. Upgrades to the 5.7L motor raised output to 390 horsepower.

How much boost can a stock 5.7 handle?

With proper tuning, a stock 5.7 / 6.1 will handle around 450hp at the crank or 7-8 lbs of boost. Without methanol injection, I would not recommend over 5 psi. The first problem to come up will be the cast pistons in these engine that start to break with detonation or power higher than 450hp.

Why was the HEMI banned from Nascar?

The HEMI engine was a mechanical marvel that was so successful it was banned from NASCAR after its first year. … By 1963, the 426-cubic-inch Wedge engine used in NASCAR was deemed to have hit its limit for horsepower.

Can the Hemi tick be fixed?

Cam, springs, rods and retainers will fix it if that’s you issue, but you’ll still have a “Hemi Tick”.

Can you stroke a 5.7 Hemi?

5.7 block can e stroked to 6.4l. You can keep MDS but the cam will be restricted in lift to keep MDS active. You are not “tuning” the engine block, you are boring it out and putting in a larger crank to increase stroke. The larger bore and stroke is what increases displacement.

What trucks have the least problems?

5 Most Reliable Trucks Ever Made (5 That Need Constant Repairs)1 Unreliable: Dodge Ram 3500. via Car and Driver.2 Reliable: Ford F-350. via Wikipedia. … 3 Unreliable: Suzuki Equator. motortrend.com. … 4 Reliable: Chevrolet Avalanche. via Wikipedia. … 5 Unreliable: Chevrolet Silverado 2500HD. autonews.com. … 6 Reliable: Nissan Frontier. … 7 Unreliable: Toyota Tacoma. … 8 Reliable: Honda Ridgeline. … More items…•

Turns out it’s also for owners of Fiat Chrysler’s Hemi 5.7-liter V-8, as the company recommends 89-octane fuel for this engine.

Can you put regular gas in a 5.7 Hemi?

The 5.7L requires 89 octane w/ auto trans and 91 octane w/ manual trans per the owner’s manual. You can run 87 octane in your car but the computer will pull timing to compensate for the inevitable spark knock that will result from using a poor grade fuel in a performance car.

Do Hemi engines need premium gas?

To reduce the chance of pinging and knocking because of higher cylinder pressures, Chrysler recommends 91 octane fuel be used with Hemi engines that are matched to a manual transmission. 87 octane fuel is considered the acceptable minimum for Hemis with manual transmissions.

Can you put a Hellcat supercharger on 5.7 Hemi?

MMX / ModernMuscleXtreme.com has released its Hellcat Supercharger adapter kit for your 5.7L (2011+) or 6.4L HEMI. … The kit can be customized and loaded with options to supercharge your experience.

How do you get a 700 horsepower out of a 5.7 Hemi?

To get 700 you’re gonna need to definitely stroke and forced induction. I would start with a 6.1 or 6.4 engine as a base and go from there. I had an 08 Charger with a 5.7 based 392 stroker and with tuning and fine parts selection I was able to get 500 rear wheel torque and horsepower all naturally aspirated.