What Muffler Will Make A V6 Sound Like A V8?

Can a 4 cylinder sound good?

Even a car with a four-cylinder engine can sound amazing.

Here are some of the best.

The 356 may not have the flat-six engine note Porsche is famous for, but its flat-four is still nice to listen to..

Can you change a v6 Mustang to a v8?

For the full swap, you will need a donor, as the easiest way. No parts other then the body with a V8 swap survive. 8.8″ rear axle to support the extra horsepower from the V8.

How much does it cost to engine swap?

As a result, expect to spend between $500 and $1,500 in labor costs, in addition to anywhere from $500 for a short block engine to $9,000 for a complete, high-performance engine.

How hard is engine swap?

You’ll have a much easier time if you follow the path someone else has already blazed. That said, if someone asked me how hard is it to swap an engine, I’d give it a 10/10 on the difficulty scale, even with a kit. There’s just so much that can go wrong if you’re not careful.

What is the best muffler for a v6?

As you can imagine, Magnaflow and flowmaster are the best. Some other cheepies sound Ok and cost less buy the catback magnaflow system is by far the most popular. Re: The best mufflers for V6 !!!!! As you can imagine, Magnaflow and flowmaster are the best.

How much does it cost to change a v6 to a v8?

New engines start at around $4,000 for a 4-cylinder, around $5,500 for a V6 and $7,000 for a V8.

Is straight piping bad for your engine?

… a race car style exhaust system is a bad upgrade for a street vehicle. … A straight pipe, for example, can cause exhaust gas velocity to increase. This will likely reduce engine performance below 2,000 or 2,500 RPM, making your vehicle a little slower to launch from a stoplight.

Can you make a v6 exhaust sound good?

Install an aftermarket tip. Dual-walled, beveled and flared tips generally amplify the sound produced by the exhaust. Exhaust tips with outlets larger than the exhaust pipe inlet may amplify sound.

How can I make my v6 faster?

How to Make a V6 Mustang FasterInstall a more free-flow exhaust. … Replace the air box with a cold-air intake. … Have the engine’s computer reprogrammed. … Install a better suspension. … Replace the stock wheels and tires with a performance wheel and tire package. … Lighten it.

How can I make my engine sound deeper?

Start the engine, and walk around the vehicle while someone revs it up, so you can hear how it sounds. If you want it a bit deeper, you can widen the cut to about a third of the pipe’s circumference. Additional cuts, spaced about four inches apart, will add depth and volume to the sound.

What type of muffler gives the deepest sound?

The Super 44 delivers a powerful rich tone and is the most aggressive, deepest sounding, highest performing 2-chamber street muffler we’ve ever built!

Can you put dual exhaust on a v6?

One option to converting to dual exhaust is to use a V6 specific mid-pipe. Designed to eliminate the single pipe design of the factory y-pipe, these bolt right up to the factory manifolds and give you a true dual exhaust. … Because this conversion gives you a true dual exhaust, you will have noticeable performance gains.

What makes a muscle car rumble?

Second, muscle cars tend to have more open exhaust systems. Again this gives less restriction at high rpm when large amounts of exhaust gas is going through the system. … The combination of these factors gives a loud, uneven rumble that you associate with muscle cars.

Can you make a v6 sound like a v8?

The only way to exactly duplicate the sound of a V8 engine in your V6 Mustang is to perform an engine swap, but there are much simpler modifications that will drastically alter the sound of your V6 Mustang so that it produces a reasonably similar exhaust note to that of a V8.

Can you make a 4 cylinder sound like a v8?

The length of the exhaust pipes on the manifold need to be long and short for each valve on each cylinder; so 4 cylinders and 8 pipes, not 4. You can make ANY 4 cylinder sound like an 8 cylinder provided you have TWO exhaust valves per cylinder and are willing to do stupid amounts of work.